4 Repair
4.3 Replacing parts (without removing covers)
Dentsply Sirona
Service Manual CEREC Primescan AC, Primescan AC, CEREC Omnicam AC, Omnicam AC
82
66 81 832 D3696
D3696.076.01.02.02 05.2019
4.3.2.1.7
Reattach the covers
1.
Remove the monitor and place it on a soft and clean base once
again as shown.
2.
Insert the 2 monitor connection covers (G) and screw the 2 screws
(F, M3 X 6 Precote) on finger tight. NOTE! Do not tighten too hard
as otherwise the plastic parts may burst!
3.
Insert the lever arm cover at the rear.
4.
Pivot the uncovered kinematics away from you against the cover
and hold it there.
5.
Insert the cables into the guides (K) (thin cable first). Ensure that
the radius is adequate (L).
