Dell PowerConnect B-FCXs, Configuration Manual

Page: 1011 / 1494

PowerConnect B-Series FCX Configuration Guide 969
53-1002266-01
Displaying OSPF information
29
The <num> parameter specifies the number of seconds and can be from 1 through 900. If you use
this parameter, the command lists the usage statistics only for the specified number of seconds. If
you do not use this parameter, the command lists the usage statistics for the previous one-second,
one-minute, five-minute, and fifteen-minute intervals.
Displaying OSPF area information
To display OSPF area information, enter the following command at any CLI level.
Syntax: show ip ospf area [ <area-id> ] | [ <num> ]
The <area-id> parameter shows information for the specified area.
The <num> parameter displays the entry that corresponds to the entry number you enter. The
entry number identifies the entry position in the area table.
This display shows the following information.
Displaying OSPF neighbor information
To display OSPF neighbor information, enter the following command at any CLI level.
To display detailed OSPF neighbor information, enter the following command at any CLI level.
TABLE 175
CLI display of OSPF area information
Field Definition
Indx The row number of the entry in the router OSPF area table.
Area The area number.
Type The area type, which can be one of the following:
•
nssa
•
normal
•
stub
Cost The area cost.
SPFR The SPFR value.
ABR The ABR number.
ASBR The ABSR number.
LSA The LSA number.
Chksum(Hex) The checksum for the LSA packet. The checksum is based on all the fields in the packet
except the age field. The Layer 3 Switch uses the checksum to verify that the packet is
not corrupted.
PowerConnect#show ip ospf area
Indx Area Type Cost SPFR ABR ASBR LSA Chksum(Hex)
1 0.0.0.0 normal 0 1 0 0 1 0000781f
2 192.147.60.0 normal 0 1 0 0 1 0000fee6
3 192.147.80.0 stub 1 1 0 0 2 000181cd
PowerConnect#show ip ospf neighbor
Port Address Pri State Neigh Address Neigh ID
8 212.76.7.251 1 full 212.76.7.200 173.35.1.220