Dell PowerConnect B-FCXs, Configuration Manual

Page: 1194 / 1494

1152 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Setting passwords
32
In this command, configure specifies that the enhanced access is for a command at the global
CONFIG level of the CLI. The level 4 parameter indicates that the enhanced access is for
management privilege level 4 (Port Configuration). All users with Port Configuration privileges will
have the enhanced access. The ip parameter indicates that the enhanced access is for the IP
commands. Users who log in with valid Port Configuration level user names and passwords can
enter commands that begin with “ip” at the global CONFIG level.
Syntax: [no] privilege <cli-level> level <privilege-level> <command-string>
The <cli-level> parameter specifies the CLI level and can be one of the following values:
•
exec – EXEC level; for example, PowerConnect> or PowerConnect#
•
configure – CONFIG level; for example, PowerConnect(config)#
•
interface – Interface level; for example, PowerConnect(config-if-6)#
•
loopback-interface – loopback interface level
•
virtual-interface – Virtual-interface level; for example, PowerConnect(config-vif-6)#
•
dot1x – 802.1X configuration level
•
ipv6-access-list – IPv6 access list configuration level
•
rip-router – RIP router level; for example, PowerConnect(config-rip-router)#
•
ospf-router – OSPF router level; for example, PowerConnect(config-ospf-router)#
•
dvmrp-router – DVMRP router level; for example, PowerConnect(config-dvmrp-router)#
•
pim-router – PIM router level; for example, PowerConnect(config-pim-router)#
•
bgp-router – BGP4 router level; for example, PowerConnect(config-bgp-router)#
•
vrrp-router – VRRP configuration level
•
gvrp – GVRP configuration level
•
trunk – trunk configuration level
•
port-vlan – Port-based VLAN level; for example, PowerConnect(config-vlan)#
•
protocol-vlan – Protocol-based VLAN level
The <privilege-level> indicates the number of the management privilege level you are augmenting.
You can specify one of the following:
•
0 – Super User level (full read-write access)
•
4 – Port Configuration level
•
5 – Read Only level
The <command-string> parameter specifies the command you are allowing users with the
specified privilege level to enter. To display a list of the commands at a CLI level, enter “?” at that
level's command prompt.
Recovering from a lost password
Recovery from a lost password requires direct access to the serial port and a system reset.
NOTE
You can perform this procedure only from the CLI.
Follow the steps given below to recover from a lost password.