Dacia Solenza 2004, Repair Manual

Page: 56 / 891

ENGINE
E7J-262
10
ENGINE ASSEMBLY
10 - 31
Mount the assembly in the block, as per
previous established sequence and check and
ensure that a
0.1 mm
gauge is passing be-
tween jackets.
Dismounting – Remounting
MOT 484
Block the jackets by means of the device
MOT 484 or the clamps MOT 588 .
Mount the base bearing on the cylinders
block. Hal-bearing lining that are mounted on
casing are provided with oiling holes.
The bearings lining are matching with the
crankshaft in two classes, as follows:
Mount connecting rod bearings (connecting
rod bearings are the same)
Lubricate the cranckpin and the bearings.
Mount the crankshaft and the axial bearings.
Mount the bearings caps. On the no.1 cap
(area
K
) apply a layer of
LOCTITE 518
, be-
tween
0.6 and 1 mm
thick.
Tighten the bearings caps to a required mo-
ment of
2.5 daNm
then to an angle of
43° ± 6°.
Check the axial clearance of the crankshaft,
which must be between:
*0.045 and 0.852 with wear;
* 0.045 and 0.252 without wear.
Marking on bearing
Red
Blue
Marking on crankshaft
A
B
Identidfication of matching classes on
crankshaft is performed by marking on the
balance-weight of bearing number 5.
Marking example on crankshaft:
A
A B A B
vnx.su