Dacia Solenza 2004, Repair Manual

Page: 354 / 891

THE MECHANICAL ELEMENTS CONTROLS
37
37 - 4
REMOUNTING
Before remounting, check: and if necessary,
perform the following adjustments:
Detach the connection screws of the rigid
brake ducts from the main brake pump.
Disconnect the electrical contact from ICP
transducer.
Dismount the main pump from the
servobrake.
Disconnect the suction hose off the
servobrake.
Servobrake
Dismount :
- the connecting shaft ( 1 ) between the
coupling fork and the pedal ;
- the attachment nuts of the servobrake
on cowl panel.
Dismount the servobrake .
1. The adjustment of the exit rod ( P1 ) ( brake
pump side) which is obtained by acting on the
nut which is one with the pushing rod, in order to
obtain value
X = 9
-0.2
mm .
This value is measured between the pushing rod
end and the rest surface of the main cylinder on
servobrake.
2. The adjustment of the pushing rod (P2)
( brake pedal side) in order to obtain the value
L = 107.7
-0.5
mm , which is obtained as follows:
- unscrew the lock nut E and by;
- act on the coupling fork (
C
) until
obtaining the value
L = 107.7
-0.5
mm
;
- lock the lock nut ( E ).
The L value, is to be measured between the
axle of the coupling fork whole and the
servobrake rest surface on cowl panel.
For remounting, perform the dismounting
operations in the reverse order.
Dismount the ICP transducer from the brake
pump.
Purge the brake circuit.
Mount the I.C.P. transducer
Mount the electric connector the I.C.P.
transducer.
1
P 2
vnx.su