Dacia Solenza 2004, Repair Manual

Page: 680 / 891

88
WIRING
88 - 9
30 PINS ADAPTER – B40
ATTENTION!
In case of an intervention at the airbag
system, it is obligatory the UCE airbag
blocking by means of the CLIP tester in
order to avoid undesirable releasing (all
releasing lines are inhibited). This
operation mode is signaled by the airbag
indicator lighting from the instrument
panel.
The adapter B40 is to be connected on
line instead of UCE airbag.
This is allowing, by means of the CLIP
tester, the control of all system lines, the
measurement of the UCE airbag supply
voltage and the compulsion of the airbag
indicator lighting from the instrument panel.
The terminals are allowing in the same time,
the performing of the checking of the
diagnostic lines continuity, of the airbag
indicator from the instrument panel and of the
UCE airbag supplying (see chapter
“
Diagnostic
”).
ATTENTION !
It is forbidd en the airb ag system
measurement by means of an ohmmeter or
any other electric measurement devices
because there is the risk of releasing due to
some device working current. (see chapter
“Diagnostic”). The airbag releasing lines are
to measured only by means of the CLIP
tester.
IDENTIFICATION OF THE EXIT
CABLES OF THE
B40 ADAPTER
1: Indicator and UCE airbag supply.
2 : Blank
A : Driver’s airbag lines
B : Passenger’s airbag lines
C: Passenger pre-tensioning lines
D: Driver’s pre-tensioning lines.
MEASUREMENT CABLES
- cables XRBAG type B32, B35.
- necessary cable for destroying the airbag.
INERT IGNITER 931066
It has the same electrical characteristics as a
real igniter and it has the purpose to replace the
airbag during the diagnostic
ATTENTION!
Before using the inert igniter, check that
its resistance value is between 1.8 and 2.5
¿
.
It is necessary to set the contact off then set
the contact on, for airbag indicator turning off
immediately after failure memory has been
erased.
Airbag – Special devices
vnx.su