Dacia Solenza 2004, Repair Manual

Page: 63 / 891

ENGINE E7J-262
10
ENGINE ASSEMBLY
10 - 38
2. Camshaft gear with marks
Rotate the engine until is reaching the Upper
Dead Point (cylinder 1 at ignition), and then con-
tinue until first item:
- adjust :
exhaust 1
exhaust 3
- at second item :
- adjust :
admission 1
admission 3
- at third item :
- adjust :
exhaust 2
exhaust 4
- at fourth item :
- adjust :
admission 2
admission 4
Dismounting – Remounting
Continue to mount:
- cylinder head cover equipped with a new cylinder head gasket, tighten the attachment
screws to the required moment of
1 daNm;
- water inlet pipe and the oil dipper guide (with new sealing rings);
- distribution casings;
- crankshaft pulley or pulleys; tighten the pulley hub screw to the required moment of
2
daNm, then to 68° ± 6°.
ATTENTION!
If the screw is not properly tighten, this may unloose, which may lead to the oil pump
non-drive and to the distribution derangement, consequently to engine damaging.
- intake manifold and exhaust manifold, tighten the attachment screws to the required mo-
ment of 2.5 daNm;
- compressor and/or power steering support;
- alternator (see chapter
16”Alternator
”);
- compressor- for vehicles equipped with air conditioning (see chapter 62 “Air condition-
ing”);
- power steering pump-for vehicles equipped with power steering (see chapter
36 “Power
steering pump”);
- belt or accessories belt according to the method described in chapter
07” Accessories
belt tensioning”.
vnx.su