Dacia Solenza 2004, Repair Manual

Page: 557 / 891

82
ACCOUSTIC WARNING - ANTI STARTING
82 - 14
Procedures
REMARK:
For the RF remote control synchronisation, after the replacement of an E.C.U. decoder,
the synchronisation procedure must be per formed taking into account the following
situations:
- fo r one R F r emote c ontr ol, pe r for m the “ SIMPLE SY N C HR ON ISED
PROCEDURE”;
- for the second RF remote control per form the “SPECIFIC SYNCHRONISED
PROCEDURE”.
B. KIT REPLACEMENT PROCEDURE
(E.C.U. decoder plus 2 key heads)
In case of one kit replacement perform the following steps:
- memorising the anti starting code by the E.C.U. decoder;
- memorising of the new anti starting code by the injection computer; it is necessary the
repairing code (found out based on the old key heads code) and the CLIP tester.
Perform the actions in the following sequence:
1. Mount the metal insertions of the old keys to the new key heads.
2. Inform by phone at ”Client Voice” (phone no 0248 500 000), the vehicle chassis series and
the key heads code, written on the vehicle invoice, in order to get the repairing code.
3. Connect the CLIP tester to the diagnostic socket and to the battery (or to the lighter
socket) of the vehicle. Read the configuration of the old E.C.U. decoder before dismounting it
off the vehicle, as follows:
- select vehicle type “B41”;
- enter the menu “ COMPUTER TEST” then select “ ANTI STARTING”;
- access “COMMAND MODE” then “READ CONFIGURATIONS”;
- note the configurations : petrol/diesel, programming with 1 or 2 keys, ceiling delayed light,
the type of the doors’ blocking switch (CPE), etc.
4. Return to the menu “ANTI STARTING”.
5. Dismount the old E.C.U. decoder and replace it with a new one, the contact being off.
6. Check the configuration of the new E.C.U. decoder selecting “ STATE LIST”; here you
must find the following states:
18G FIRST KEY MEMORISING……………………………........… PASSIVE
19G NOT PERFORMED KEY PROGRAMMING ……………….....ACTIVE
19D UNBLOCKED KEY PROGRAMMING ……………………..... ACTIVE
REMARK:
If the state 19G and 19D are not “ACTIVE” this means the E.C.U. decoder isn’t a
new one and cannot memorise another anti starting code.
vnx.su