![background image](http://html1.mh-extra.com/html/club-car/fe290/fe290_maintenance-service-supplement_2626734072.webp)
ELECTRICAL COMPONENTS
Accelerator Pedal Limit Switch
Page 12-16 2000 FE290 Gasoline Vehicle Maintenance and Service Supplement
12
ACCELERATOR PEDAL LIMIT SWITCH
Read DANGER and WARNING on page 12-1.
Testing the Accelerator Pedal Limit Switch
See Test Procedure 5, Section 11, Page 11-23.
Accelerator Pedal Limit Switch Removal
1. Disconnect battery wires as shown (Figure 12-1, Page 12-2).
2. Remove electrical component box cover (1) (Figure 12-18, Page 12-17).
3. Disconnect the green wire and the orange wire from the accelerator pedal limit switch (11) (Figure 12-18,
Page 12-17).
4. Remove the two nuts (9) and washers (10) that secure the accelerator limit switch in place.
5. Remove the accelerator pedal limit switch.
Accelerator Pedal Limit Switch Installation
1. Install the accelerator pedal limit switch (11) onto the two screws (16) and secure the switch using two
washers (10) and nuts (9). Torque to 5 in-lb (0.6 N·m) (Figure 12-18, Page 12-17).
2. Connect the green wire to common (COM) terminal and the orange wire to the normally closed (NC)
terminal of the accelerator pedal limit switch (Figure 12-18, Page 12-17).
3. Depress the accelerator pedal to make sure that the switch is being actuated when the pedal is released.
4. Connect battery cables, positive cable first, and tighten terminals to 20 ft-lb (27.1 N·m) (Figure 12-1,
Page 12-2). Coat terminals with Battery Protector Spray (Club Car Part No. 1014305).
KILL LIMIT SWITCH
Read DANGER and WARNING on page 12-1.
Testing the Kill Limit Switch
See Test Procedure 16, Section 11, Page 11-31.
Kill Limit Switch Removal
1. Disconnect battery cables as shown (Figure 12-1, Page 12-2).
2. Remove electrical component box cover (1) (Figure 12-18, Page 12-17).
3. Remove the nuts (9) and washers (10) that secure the accelerator pedal limit switch (11). Do not dis-
connect the wires attached to this switch (Figure 12-18, Page 12-17).
4. Disconnect the two white/black wires and the black wire from the kill limit switch (12).
5. Remove the kill limit switch (12).
Kill Limit Switch Installation
1. Install the kill limit switch (12) onto the screws (16) (Figure 12-18, Page 12-17).
2. Connect the two white/black wires to the common (COM) terminal and the black wire to the normally
open (NO) terminal of the kill limit switch (12).
3. Install the accelerator pedal limit switch (11) onto the screws (16). Secure the switch with washers (10)
and nuts (9). Tighten to 5 in-lb (0.6 N·m).
• DO NOT OVER-TIGHTEN THE RETAINING NUTS. IF THE NUTS ARE OVER-TORQUED, THE
LIMIT SWITCHES COULD BE DAMAGED.
WARNING