![background image](http://html1.mh-extra.com/html/club-car/fe290/fe290_maintenance-service-supplement_2626734111.webp)
FE290 ENGINE
Crankcase
2000 FE290 Gasoline Vehicle Maintenance and Service Supplement Page 13-23
13
6. Remove engine mounting hardware (Items 1, 2, 5 and 6) (Figure 13-48, Page 13-25).
7. Lift engine from the mounting plate.
8. Remove crankcase oil drain plug and filler tube. Tip the engine slightly to allow all of the oil to drain
from the crankcase. Dispose of engine oil properly.
CRANKCASE COVER REMOVAL
1. Remove yellow jumper wire (11) from cord connector (12) (Figure 13-46, Page 13-24).
2. Remove nuts and clamps at two-ended bolts (1 and 2) (Figure 13-44, Page 13-24).
3. Remove eight bolts (3) and remove the crankcase cover (4) (Figure 13-44, Page 13-24). See
following NOTE.
4. Remove the crankcase cover gasket completely. It may stick to the flanged surface of the crankcase.
Figure 13-44 Crankcase Cover
Figure 13-45 Timing Marks
Figure 13-46 Oil Level Sensor Wire
Figure 13-47 Oil Level Sensor
• IF THE CRANKCASE COVER STICKS, TAP LIGHTLY WITH A PLASTIC MALLET ON ALTERNATE
SIDES NEAR THE DOWEL PINS (5) (FIGURE 13-44, PAGE 13-24).
3
4
1
2
5
5
1
STARTER/
GENERATOR
12
11
TYPICAL 2
PLACES
TYPICAL 3
PLACES
1
4
3
2
9
8
5
6
7
NOTE