![background image](http://html1.mh-extra.com/html/club-car/fe290/fe290_maintenance-service-supplement_2626734110.webp)
FE290 ENGINE
Crankcase
Page 13-22 2000 FE290 Gasoline Vehicle Maintenance and Service Supplement
13
Installation of Remaining Engine Components, Continued:
8. Install governor cable clevis pin (9) through cable clevis and throttle valve and install cotter pin (10).
9. Install the governor guard (8), flat washer and nylon lock nut. Tighten to 30 in-lb (3.4 N·m) (Figure 13-
43, Page 13-23).
10. Apply a light film of clean engine oil onto the seal of the new oil filter and install the filter. Tighten the fil-
ter 2/3 turn after gasket contact. Fill crankcase with the correct level of oil (Figure 13-106, Page 13-
48). See Section 10 – Periodic Maintenance.
11. Run the engine for three minutes to check for leaking oil.
CRANKCASE
Read DANGER and WARNING on page 13-1.
ENGINE REMOVAL
To perform repairs on crankcase components, the engine must be removed from the vehicle.
1. Remove the powertrain by performing steps 1 through 14, pages 16-7 through 16-10 in Section 16 –
Unitized Transaxle.
2. Remove starter-generator. See Section 12 – Electrical System.
3. Remove drive belt. See Section 17 – Torque Converter.
4. Remove drive clutch. See Section 17 – Torque Converter and following NOTE.
5. Remove muffler. See Section 15 – Exhaust System.
Figure 13-42 Oil Filler Tube and Ground Wire
Figure 13-43 Governor Cable Connection
• BEFORE REMOVAL AND DISASSEMBLY, CLEAN THE ENGINE.
• THE CRANKSHAFT HAS LEFT-HAND THREADS AT THE CLUTCH MOUNTING HOLE.
1
7
6
5
2
3
4
8
12
11
8
10
9
13
14
15
CAUTION
NOTE