FE290 ENGINE
Cylinder Head
Page 13-8 2000 FE290 Gasoline Vehicle Maintenance and Service Supplement
13
Cylinder Shroud Removal, Continued:
5. Remove governor guard (1) (Figure 13-6, Page 13-9).
6. Remove cotter pin (3) and clevis pin (2) from throttle lever (Figure 13-6, Page 13-9).
7. Remove nuts at carburetor intake pipe (5) and remove intake pipe (Figure 13-6, Page 13-9). See fol-
lowing CAUTION.
8. Remove carburetor (4) along with throttle spring (8) and throttle spring bracket (23) (Figure 13-6,
Page 13-9).
9. Remove muffler. See Section 15 – Exhaust System.
10. If the engine is to be totally disassembled, drain oil and remove
the oil filter. If only the cylinder head is
to be disassembled, proceed without draining the oil or removing the oil filter.
• PLUG FUEL LINE TO PREVENT GAS FROM DRAINING FROM LINE.
Figure 13-5 Carburetor
Figure 13-6 Carburetor Removal
• DISCONNECT THE GOVERNOR LINKAGE FROM THE CARBURETOR BEFORE ATTEMPTING
TO REMOVE THE CARBURETOR. FAILURE TO DO SO COULD DAMAGE THE LINKAGE.
WARNING
4
9
10
7
8
5
4
1
6
3
2
23
CAUTION
