![background image](http://html1.mh-extra.com/html/club-car/fe290/fe290_maintenance-service-supplement_2626734082.webp)
ELECTRICAL COMPONENTS
Oil Level Sensor
Page 12-26 2000 FE290 Gasoline Vehicle Maintenance and Service Supplement
12
Ignition Coil Installation, Continued:
12. Position the fan housing close to the engine crankcase and install the plug wire grommet into the notch
on the housing.
13. While installing fan housing, make sure the top front corner of the housing is above the upper cylinder
shroud. The front edge of the fan housing should be behind the lower cylinder shroud. Align the slots in
the housing with the flanged head bolts loosened earlier.
14. Install the four remaining flange bolts that secure the fan housing to the engine crankcase. Tighten all
seven mounting bolts to 90 in-lb (10.1 N·m) (Figure 12-27, Page 12-24).
15. Install the stiffener with four hex head bolts and locknuts. Tighten the hardware to 23 ft-lb (31.2 N·m)
(Figure 12-26, Page 12-24).
16. Tie wrap the wire harness to the stiffener. Insert tie wrap through the lower hole at the back of the
stiffener.
17. Install the fan shroud with four pan head bolts. Tighten to 50 in-lb (5.7 N·m) (Figure 12-27,
Page 12-24).
18. Install the muffler. See Section 15 – Exhaust System.
19. Place the governor guard (1) onto the throttle bracket and the 2-ended bolt. Install the two torx screws
(4) through the governor guard into the throttle bracket and tighten to 15 in-lb (1.7 N·m). Place the 3/8
flat washer (3) onto the 2-ended bolt and secure with nylon locknut (2). Tighten the nut to 50 in-lb (5.7
N·m) (Figure 12-25, Page 12-24).
20. Connect the spark plug wire to the spark plug.
21. Connect battery cables, positive cable first, and tighten terminals to 20 ft-lb (27.1 N·m) (Figure 12-1,
Page 12-2). Coat terminals with Battery Protector Spray (Club Car Part No. 1014305).
OIL LEVEL SENSOR
Read DANGER and WARNING on page 12-1.
Testing the Oil Level Sensor
See Test Procedure 21, Section 11, Page 11-33.
Oil Level Sensor Removal
See Oil Level Sensor Removal, Section 13 – FE290 Engine, Page 13-24.
Oil Level Sensor Installation
See Oil Level Sensor Installation, Section 13 – FE290 Engine, Page 13-24.
BATTERY
Read DANGER and WARNING on page 12-1.
• MAKE SURE WIRE HARNESS IS ROUTED AWAY FROM MUFFLER.
CAUTION