ELECTRICAL COMPONENTS
Starter/Generator
Page 12-6 2000 FE290 Gasoline Vehicle Maintenance and Service Supplement
12
Disassembly of the Starter/Generator, Continued:
2. Remove the two bolts (20) and pull commutator end cover (23) free of the starter/generator housing
(24) (Figure 12-3, Page 12-4).
3. To separate armature (33) from output end cover (36), remove nut (41), lockwasher (40), pulley (39),
shaft key (34), spacer (37) and bearing retainer screws (43) (Figure 12-8, Page 12-6).
Bearing Cleaning and Inspection
1. Using a clean cloth, wipe the carbon dust from the two bearings. Inspect bearings by spinning them by
hand and checking for both axial (A) and radial (B) play (Figure 12-9, Page 12-6).
2. Replace the bearing if it is noisy, does not spin smoothly, or has excessive play. Check the bearings
and replace if rusted, worn, cracked, or if there is an abnormal color change in the metal of the bearing.
Bearings should be replaced if there is extensive wear or pitting on the balls or on the rolling surfaces.
Do not remove the bearings unless they are to be replaced.
Figure 12-8 Armature and Output End Cover Assembly
Figure 12-9 Bearing Play Inspection
33
34
41
40
39
35
32
TYPICAL
3 PLACES
37
43
36
A
B