TORQUE CONVERTER
Driven Clutch
2000 FE290 Gasoline Vehicle Maintenance and Service Supplement Page 17-15
17
9. While holding onto the cam, tap the end of the fixed face shaft lightly with a plastic mallet until the cam
seats against the retaining ring. See following CAUTION.
DRIVEN CLUTCH INSTALLATION
1. To install the driven clutch, reverse the removal procedure. Before tightening the center bolt (11) to 14
ft-lb (19.0 N·m), make sure the mounting washer (12) is installed between the center bolt and the clutch
(yellow side facing out) (Figure 17-16, Page 17-12).
• THE RETAINING RING CAN BE REUSED IF THE O.D. DOES NOT EXCEED 1.607 INCHES (40.82
MM). OTHERWISE IT MUST BE REPLACED WITH A NEW RING (CLUB CAR PART NO. 1014080).
• DO NOT USE A METAL HAMMER TO TAP THE FIXED FACE HUB. A METAL HAMMER WILL
DAMAGE THE SHAFT.
NOTE
CAUTION