UNITIZED TRANSAXLE
Component Disassembly
2000 FE290 Gasoline Vehicle Maintenance and Service Supplement Page 16-21
16
2. Place the bearing puller wedge attachment under the bearing (59) and press the bearing from the shaft
(Figure 16-42, Page 16-18). See following CAUTION.
3. Press the gear (58) from the shaft (56), then remove the key (57) (Figure 16-42, Page 16-18).
IDLER SHAFT DISASSEMBLY
1. Place a bearing puller wedge attachment (Club Car Part No. 1012812) between the bearing (66) and
the small gear on the idler shaft (65) (Figure 16-42, Page 16-18), then press the bearing off the shaft
as shown (Figure 16-51, Page 16-22). See following CAUTION.
2. Place a bearing puller wedge attachment (Club Car Part No. 1012812) between the bearing and the
larger gear on the idler shaft (65) (Figure 16-42, Page 16-18), then press the bearing off the shaft as
shown (Figure 16-52, Page 16-22).
Figure 16-46 Differential Pin
Figure 16-47 Remove Bearing
• DO NOT TIGHTEN THE BEARING PULLER WEDGE ATTACHMENT AGAINST THE SHAFT. THE
SHAFT COULD BE DAMAGED WHEN PRESSING THE BEARING OFF.
Figure 16-48 Remove Bearing
Figure 16-49 Remove Bearing
Push
differential
pin through
differential
gear case.
Use a 1-3/8 in. o.d.
arbor and a
bearing puller
wedge attachment
(Club Car Part
No. 1012812)
to press bearing
from gear case.
ARBOR
PRESS
RAM
WEDGE
ATTACHMENT
CAUTION
ARBOR
PRESS
RAM
WEDGE
ATTACHMENT
PRESS RAM
BEARING PULLER
WEDGE ATTACHMENT