UNITIZED TRANSAXLE
Unitized Transaxle Removal
Page 16-12 2000 FE290 Gasoline Vehicle Maintenance and Service Supplement
16
21. Remove the six bolts mounting the unitized transaxle to the engine.
21.1. Remove four transaxle mounting bolts (one at each corner of the transaxle mounting plate) as
shown (Figure 16-34, Page 16-13).
21.2. Remove two middle transaxle mounting nuts as shown (Figure 16-34, Page 16-13).
22. Remove the leaf springs, wheels and brake assemblies from the transaxle.
Figure 16-26 Raise Vehicle
Figure 16-27 Position Jack Stands
Figure 16-28 Snubber
Figure 16-29 Remove Powertrain
ClubCar
ClubCar
Raise rear of vehicle until
powertrain can be rolled out.
ClubCar
ClubCar
With jack stands
in place, remove
floor jack.
JACK STAND
JACK STAND
Club Car
Vehicle body and frame
remain stationary on
jack stands while
powertrain is rolled
out of the
vehicle.
Lift snubber
out of bracket.
SNUBBER
BRACKET
Roll entire
powertrain
out from under
vehicle body.
Lower snubber
to the ground.
