FE290 ENGINE
Crankcase
Page 13-24 2000 FE290 Gasoline Vehicle Maintenance and Service Supplement
13
OIL LEVEL SENSOR
Testing the Oil Level Sensor
See Section 11, Test Procedure 21, Page 11-33.
Oil Level Sensor Removal
1. If not already removed, remove crankcase cover. See Crankcase Cover Removal, Page 13-24.
2. Disconnect the oil level sensor wire (2) from the cord connection (1) (Figure 13-47, Page 13-24).
3. Remove the screw (3) from the wire clamp (4).
4. Remove the two mounting screws from the inside of the crankcase cover and remove the oil level
sensor and bracket.
5. If necessary, remove the three screws (7) that hold the sensor to the bracket (5).
Oil Level Sensor Installation
1. If the oil level sensor was removed from the bracket, install sensor (6) into bracket (5) and secure with
three screws (7) (Figure 13-47, Page 13-24). Tighten to 16.8 in-lb (1.9 N·m).
2. Position sending unit and bracket on inside of crankcase and install two mounting screws.
3. Connect sensor wire (2) to cord connector (1) (Figure 13-47, Page 13-24).
4. Install screw (3) through wire clamp and into crankcase cover. Tighten to 30 in-lb (3.4 N·m).
Figure 13-48 Engine Mounting Plate
TYPICAL
2 PLACES
TYPICAL
4 PLACES
ClubCar
3
1
4
5
2
ClubCar
TYPICAL
2 PLACES
6