![background image](http://html1.mh-extra.com/html/club-car/fe290/fe290_maintenance-service-supplement_2626734098.webp)
FE290 ENGINE
Cylinder Head
Page 13-10 2000 FE290 Gasoline Vehicle Maintenance and Service Supplement
13
Rocker Arm and Push Rod Removal, Continued:
2. Remove the E-ring (4) and pull the rocker shaft (5) out of the cylinder head (Figure 13-10,
Page 13-10).
3. Lift out the rocker arms (6), washer (7), and push rods (8) (Figure 13-10, Page 13-10).
CYLINDER HEAD REMOVAL
1. Remove the six bolts (1) and remove the cylinder head assembly (2) (Figure 13-11,
Page 13-11).
2. Remove head gasket (3). Note the position of the two dowels (4) as shown (Figure 13-12,
Page 13-11).
VALVE REMOVAL
1. Compress the valve spring with the valve spring compressor (5) (Club Car Part No. 101641101) and
remove the collet halves (6) (Figure 13-13, Page 13-12).
2. Remove spring compressor, and take out the upper retainer (7) and the spring (8).
3. Remove valve (10).
4. Remove valve stem seal (11) with a screwdriver (Figure 13-14, Page 13-12). See following CAUTION.
5. Remove spring seat (9) (Figure 13-14, Page 13-12).
Figure 13-11 Cylinder Head
Figure 13-12 Head Gasket
• TO KEEP THE SCREWDRIVER FROM DAMAGING THE CYLINDER HEAD FLANGE SURFACE,
PLACE A PIECE OF HEAVY CARDBOARD OR WOOD BETWEEN THEM (FIGURE 13-14,
PAGE 13-12).
• THE VALVE STEM SEAL CANNOT BE REUSED. REPLACE VALVE STEM SEAL WITH A NEW
ONE.
2
1
1
1
1
1
1
4
3
CAUTION