FE290 ENGINE
Oil Pump
2000 FE290 Gasoline Vehicle Maintenance and Service Supplement Page 13-31
13
Ignition Coil Installation
1. Installation is the reverse of removal.
2. While tightening the two bolts (3), use a bronze feeler gauge to adjust the ignition coil air gap to 0.012
inch (0.304 mm) (Figure 13-64, Page 13-32).
3. Tighten the two ignition coil bolts to 30 in-lb (3.4 N·m).
OIL PUMP
Read DANGER and WARNING on page 13-1.
Oil Pump Cover Removal
1. Remove the six screws (1) and take off the oil pump cover (2) (Figure 13-65, Page 13-32).
2. Peel off the oil pump cover gasket (3).
3. Remove the pump gear cover plate (4) (Figure 13-65, Page 13-32).
Figure 13-63 Flywheel Nut Removal
Figure 13-64 Adjust Ignition Coil Air Gap
Figure 13-65 Oil Pump
5
7
4
M
F
34
81
0.012"
(0.304 mm)
3
TYPICAL 6
PLACES
1
1
3
5
2
6
4
2
2
3
4
5
BOLT TIGHTENING
SEQUENCE
REF.
