UNITIZED TRANSAXLE
Component Disassembly
2000 FE290 Gasoline Vehicle Maintenance and Service Supplement Page 16-19
16
3. Remove the differential gear (90) from the differential gear carrier case (Figure 16-5, Page 16-4).
4. Remove the differential pin (88) (Figure 16-5, Page 16-4) by pushing it through from one side
(Figure 16-46, Page 16-21). Remove the two differential idler gears (89) and two idler gear thrust
plates (85) (Figure 16-5, Page 16-4) as the pin is driven through.
5. Remove the differential gear (91) from the carrier case (Figure 16-5, Page 16-4).
6. If the bearings (79) are to be removed, place a bearing puller wedge attachment (Club Car Part No.
1012812) between the bearing and gear case (84) (Figure 16-5, Page 16-4) and press the bearing off
as shown (Figure 16-47, Page 16-21). Repeat the process for the bearing on the carrier cover (87)
(Figure 16-5, Page 16-4). See following CAUTION.
Figure 16-43 Remove Governor Gear
Figure 16-44 Pry Gear from Shaft
Figure 16-45 Remove Ring Gear
• IT MAY BE NECESSARY TO DRIVE THE DIFFERENTIAL PIN OUT WITH HAMMER AND PUNCH.
• DO NOT TIGHTEN THE BEARING PULLER WEDGE ATTACHMENT AGAINST THE SHAFT. THIS
COULD DAMAGE THE SHAFT.
ClubCar
Using a hammer and
drift punch, lightly tap
governor gear and
washer from case.
ClubCar
Pry governor gear assembly from
shaft using two small screwdrivers.
Remove eight ring gear
retaining bolts ...
Then turn differential gear assembly
over and tap around ring gear with a
rubber or plastic mallet to loosen and
remove the ring gear.
NOTE
CAUTION
