![background image](http://html1.mh-extra.com/html/club-car/fe290/fe290_maintenance-service-supplement_2626734206.webp)
UNITIZED TRANSAXLE
Unitized Transaxle Installation
Page 16-36 2000 FE290 Gasoline Vehicle Maintenance and Service Supplement
16
Unitized Transaxle Installation, Continued:
19. Connect the engine kill switch wire (18 gauge white/black stripe) to the bullet connector at the lower
right front of the engine (Figure 16-94, Page 16-37).
20. Connect the oil level sensor wire (18 gauge yellow) to the jumper wire (Figure 16-95, Page 16-37).
21. Connect the 6 gauge white wire to the F2 post, the 6 gauge black ground wire to the A2 post and
tighten to 48 in-lb (5.4 N·m). Connect the 16 gauge yellow wire to the DF post on the starter/generator
and tighten to 30 in-lb (3.4 N·m) (Figure 16-96, Page 16-37).
Figure 16-89 Driven Clutch
Figure 16-90 Snubber
Figure 16-91 Leaf Springs
Figure 16-92 Leaf Springs and Shackles
Install key onto input shaft.
Club Car
SNUBBER
BRACKET
SNUBBER
Roll powertrain under vehicle, then
lift snubber into the snubber bracket.
Position floorjack under
trailer hitch bracket, then
lower vehicle until front
spring and shackles
are in alignment.
TRAILER HITCH
BRACKET
Insert bolts through
leaf springs and
front mounts on
both sides of vehicle.
Install washers
and nuts on bolts.
Continue using floorjack
to lower (or raise) the
vehicle in order to align
the rear shackles and
leaf springs before
installing bolts, washers
and nuts.