UNITIZED TRANSAXLE
Unitized Transaxle Removal
Page 16-8 2000 FE290 Gasoline Vehicle Maintenance and Service Supplement
16
Unitized Transaxle Removal, Continued:
3.4. Loosen the hose clamp and then disconnect the fuel line from the carburetor. To prevent spilling
fuel, the disconnected end of the line can be pushed onto the impulse line fitting of the fuel pump
(Figure 16-12, Page 16-8).
3.5. Remove the cover from the electrical component box. Then loosen the hardware securing the
accelerator cable to the box. Disconnect the cable from the actuator cam and remove it from the
box (Figure 16-13, Page 16-8).
3.6. Disconnect the engine ground wire from oil filler tube mounting bracket (Figure 16-14, Page 16-9).
3.7. Loosen nuts securing shifter cable to shifter cable mounting bracket. Then disconnect the shifter
cable rod end from the shifter arm on the unitized transaxle and remove the cable from the cable
mounting bracket (Figure 16-15, Page 16-9).
3.8. Mark for proper reconnection and then disconnect the 6 gauge white wire (F2 post), 6 gauge
black ground wire (A2 post), and 16 gauge yellow (DF post) from starter/generator (Figure 16-16,
Page 16-9).
3.9. Disconnect the oil level sensor wire (18 gauge yellow) at the connector just to the rear of the
starter/generator) (Figure 16-17, Page 16-9).
3.10. Disconnect the engine kill switch wire (18 gauge white/black stripe) from the bullet connector at
the lower right front of the engine (Figure 16-18, Page 16-10).
Figure 16-10 Air Intake Hose
Figure 16-11 Impulse Line
Figure 16-12 Fuel Line
Figure 16-13 Throttle Cable
Club Car
Remove
air intake hose
clamp.
Squeeze clamp
to remove
impulse line.
IMPULSE LINE
Club Car
Remove fuel line.
Loosen retaining nuts
to remove throttle
cable from electric box.
TOP VIEW
