Appendix 1: Technical Specifications
249
Mask creation: Limit test vertical tolerance from 0 to 1 division; limit test horizontal tolerance from 0 to 500 m division. Load
standard mask or custom mask
Mask scaling: Lock to source on, lock to source off
Test run time: Minimum number of waveforms (from 1 to 1,000,000 and infinity); the shortest time (1 s-48 h; infinity)
Violation threshold: 1~1000000
Actions on test failure: Stop acquisition, save screen image to file, save waveform to file, and trigger out pulse
Actions on test complete: Trigger out pulse
Result display: Test status, total waveforms, number of violations, violation rate, total tests, failed tests, test failure rate, elapsed
time, and total hits for each mask segment
Power measurement and
analysis
(Option S02)
Power quality test: V
RMS
, V
crest factor
, frequency, I
RMS
, I
crest factor
, active power, apparent power, reactive power, power factor, phase
angle
Switching loss measurement: Power loss and energy loss, including T
on
, T
off
, conduction, total loss
Harmonics: THD-F, THD-R, RMS measurement, harmonic graphic display and table display
Ripple measurement: V
ripple
and I
ripple
Modulation analysis: Graphic display of modulation types incpulse width, -pulse width, period, frequency, +duty ratio
and -duty ratio
Safety operation area: Graphic display of measurement of safety operation areas of the switching equipment and template test
Measurement of dV/dt and dI/dt: Conversion rate marker measurement
Protocol
Analyzer
Options
Decode channel
1
Display format
Binary, hexadecimal
Display
Bus, digital, event list with time scale information.
I
2
C option
S04
Trigger on start, repeated start, stop, missing ACK, address, data, or address and data on I
2
C buses up to 10 Mb/s.
Signal rate:
≤
10Mbps; Protocol type: 7 digits /10 digits address
RS232 trigger and
analysis option S05
Trigger on Tx start bit, Rx start bit, Tx end of packet, Rx end of packet, Tx data, Rx data, Tx parity error, and Rx parity error up
to 2Mbps.
Signal rate: 50bps~2Mbps
SPI trigger and analysis
option S06
Trigger on start of frame, MOSI, MISO, or MOSI and MISO on SPI buses up to 10 Mbps
Signal rate:
≤
10Mbps
Summary of Contents for 4456 Series
