Ceyear 4456 Series, User Manual

Page: 138 / 267

Chapter XI Protocol Analyzer (Option)
128
Fig. 11.157 Numeric Keypad
Set the data value through keys on the numeric keypad or Multipurpose a and Multipurpose b.
Click [Data Low] or [Data High] menu key, and the numeric keypad same as the [Data] menu key setting as
shown in the above figure will pop up on the left side of the menu, and the setting method is the same.
Click [ID/Data] menu key and set the FlexRay trigger type to ID/Data, and the menu at the bottom of the screen
will be switched to the ID/Data Trigger Type setup menu:
Fig. 11.158 FlexRay ID and Data Trigger Level1 Menu
For specific operations, refer to identifier trigger type and data trigger type respectively.
Click [End of Frame] menu key and set the FlexRay trigger type to End of Frame, and the menu at the bottom of
the screen will be switched to the End of Frame Trigger Type setup menu:
Fig. 11.159 FlexRay End of Frame Trigger Level1 Menu
Click [End of Frame] menu key, and the Error Type selection menu will pop up on the right side of the screen:
Fig. 11.160 FlexRay End of Frame Trigger Level2 Menu
Click [Static], [Dynamic] and [Full] keys of the menu to set the End of Frame to Static, Dynamic and Full.
Click [Error] menu key and set the FlexRay protocol trigger type to Error, and the menu at the bottom of the
screen will be switched to the Error Trigger Type setup menu:
Fig. 11.161 FlexRay Error Trigger Level1 Menu
Click [Error Type] menu key, and the Error Type selection menu will pop up on the right side of the screen:
Fig. 11.162 FlexRay Error Trigger Level2 Menu
Click [Header CRC] and [Trailer CRC] to set the error type to Header CRC Error and Trailer CRC Error
respectively.