Chapter XIX Application Examples
242
Frame
Start
Left
Data
Frame
End
Right
Data
Fig. 19.10 Audio Trigger and Analysis Example
19.11 USB Trigger and Analysis Example
If you want to observe the transmission of signals on the USB bus, you can follow these steps below:
1)
Connect D+ line of the USB bus to the channel 1, connect the D- line to the channel 2, and click the channel
control key on the front panel to open the channels 1 and 2;
2)
Press the
【
Bus
】
key in the Function Area on the front panel to pop up the bus setup menu on the lower
screen. Click the [Bus] menu key on the menu to pop up the bus type selection menu on the right side of the
screen. Click the [USB] menu key, select the USB, and switch to the USB setup menu at the bottom of the
screen;
3)
Click the menu key [Bus Switch] at the bottom of the screen to turn on the bus decoding function;
4)
Click the [Define Inputs] menu key to pop up the USB input setup menu on the right side of the screen. Click
the [Speed] menu key to select the Low.
5)
Click the menu key [Signal Type] to select the Single-ended.
6)
Click the menu key [D+] to pop up the Level3 Menu of D+ channel input selection on the left side of the
menu. Select the channel 1 by turning the Multipurpose b and then pressing the Multipurpose b to confirm
Select, or by directly clicking the channel 1 in the Level3 Menu on the screen. The selected channel is
displayed in the channel selection menu on the right side;
7)
Click the menu key [D-] to pop up the Level3 Menu of D- channel input selection on the left side of the
menu. Select the channel 2 by turning the Multipurpose b and then pressing the Multipurpose b to confirm
Select, or by directly clicking the channel 2 in the Level3 Menu on the screen. The selected channel is
displayed in the channel selection menu on the right side;
8)
Click the menu key [Thresholds] to pop up the USB channel threshold setup menu on the right side of the
screen. Click the menu key [D+] and turn the Multipurpose b to set the threshold of D+ input channel. Click
the menu key [D+] and turn the Multipurpose b to set the threshold of D+ input channel, or click the menu
key [Choose Preset] to pop up the Level3 Menu of the preset type selection on the left side of the menu and
turn the Multipurpose b to select the preset threshold and then press the Multipurpose b to select the
corresponding preset type or directly click the corresponding type for selection on the screen. Set the
Threshold of D- channel in the same way;
9)
Click the menu key [Bus Display] to pop up the USB bus display setup menu on the right side of the screen,
click the menu key [Display] to pop up the Level3 Menu of the bus display mode on the left side of the menu,
turn the Multipurpose b to select the bus and waveform display mode and then press the Multipurpose b to
confirm Select, or set directly by clicking the Bus and Waveforms option in the Level3 Menu; click the menu
key [Number Format] to pop up the Level3 Menu of the number format setting on the left side of the menu,
Summary of Contents for 4456 Series
