BLEMO ER24 Series, Programming Manual

Page: 67 / 344

Monitoring Mode (MOn)
69
Code Nam e / De s cription Unit
AFI-
[MORE FAULT INFO]
Additional detected fault information.
CnF
[Network fault]
Communication option card fault code.
This parameter is read-only. The fault code remains saved in the parameter, even if the cause disappears. The parameter is reset
after the drive is disconnected and then reconnected. The values of this parameter depend on the netw ork card. Consult the
manual for the corresponding card.
ILF1 [Internal link fault 1]
Communication interruption betw een option card 1 and drive.
This parameter is read-only. The fault code remains saved in the parameter, even if the cause disappears. The parameter is reset
after the drive is disconnected and then reconnected.
SFFE [Safety fault reg.] (1)
Safety function fault error register.
Bit0 = 1: Logic inputs debounce time-out (verify value of debounce time LIDT according to the application)
Bit1 Reserved
Bit2 = 1: Motor speed sign has changed during SS1 ramp
Bit3 = 1: Motor speed has reached the frequency limit threshold during SS1 ramp.
Bit4: Reserved
Bit5: Reserved
Bit6 = 1: Motor speed sign has changed during SLS limitation
Bit7 = 1: Motor speed has reached the frequency limit threshold during SS1 ramp.
Bit8: Reserved
Bit9: Reserved
Bit10: Reserved
Bit11: Reserved
Bit12: Reserved
Bit13 = 1: Not possible to measure the motor speed (verify the motor w iring connection)
Bit14 = 1: Motor ground short-circuit detected (verify the motor w iring connection)
Bit15 = 1: Motor phase to phase short-circuit detected (verify the motor w iring connection)
SAF1
[Safety fault Reg1] (1)
Safety fault register 1.
Application control error register.
Bit0 = 1: PWRM consistency detected error
Bit1 = 1: Safety functions parameters detected error
Bit2 = 1: Application auto test has detected an error
Bit3 = 1: Diagnostic verification of safety function has detected an error
Bit4 = 1: Logical input diagnostic has detected an error
Bit5 = 1: SMS or GDL safety functions detected error (Details in
[SAFF Subcode 4] SF04 register page 71 )
Bit6 = 1: Application w atchdog management active
Bit7 = 1: Motor control detected error
Bit8 = 1: Internal serial link core detected error
Bit9 = 1: Logical input activation detected error
Bit10 = 1: Safe Torque Off function has triggered an error
Bit11 = 1: Application interface has detected an error of the safety functions
Bit12 = 1: Safe Stop 1 function has detected an error of the safety functions
Bit13 = 1: Safely Limited Speed function has triggered an error
Bit14 = 1: Motor data is corrupted
Bit15 = 1: Internal serial link data flow detected error
(1) Hexadecimal values are displayed on the Graphic display terminal
Example:
SFFE =
0x0008 in Hexadecimal
SFFE = Bit 3
Parameters described in this page can be accessed by:
DRI- > MON- > AFI-