BLEMO ER24 Series, Programming Manual

Page: 233 / 344

Configuration Mode (ConF)
235
Configuration information output
In the [INPUTS / OUTPUTS CFG] (I_O-) m enu, a logic output can be as s igned to each configuration or
m otor (2 or 3) for rem ote inform ation trans m ission.
Note:
As the
[INPUTS / OUTPUTS CFG]
(I_O-) m enu is s witched, thes e outputs m ust be as s igned in all
configurations in which inform ation is required.
Code Nam e / De s cription Adjus tment range Factory s e tting
FUn-
[APPLICATION FUNCT.] (continued)
MMC-
[MULTIMOTORS/CONFIG.]
CHM
nO
YES
[Multimotors] [No]
(nO)
NOTICE
MOTOR OVERHEATING
When the drive is s witched off, the therm al s tates of the connected m otors are not s aved.
When the drive is s witched on again, the drive is not aware of the therm al s tates of the connected m otors .
•
Us e s eparate tem perature sensors for each connected m otor for therm al m onitoring.
Failure to follow these instructions can result in equipment damage.
[No] (nO) : Multiconfiguration possible
[Ye s ]
(YES) : Multimotor possible
CnF1
nO
LI1
...
[2 Configurations]
[No] (nO)
Sw itching of 2 motors or 2 configurations.
[No] (nO) : No sw itching
[LI1] (LI1) : Logical input LI1
[...]
(...) : See the assignment conditions on page 153
CnF2 [3 Configurations] [No]
(nO)
Sw itching of 3 motors or 3 configurations.
Identical to [2 Configurations ] (CnF1) page 235 .
Note : In order to obtain 3 motors or 3 configurations, [2 Configurations ] (CnF1) must also be configured.