BLEMO ER24 Series, Programming Manual

Page: 193 / 344

Configuration Mode (ConF)
195
Code Nam e / De s cription Adjus tment range Factory s e tting
bIr [Brake release freq] [Auto]
(AUtO) to 10 Hz
[Auto]
(AUtO)
* Brake release frequency threshold (initialization of acceleration ramp).
This parameter can be accessed if
[M ove m e nt type ] (bSt) page 194 is set to [Hois ting] (UEr) .
[Auto]
(AUtO) : The drive takes a value equal to the rated slip of the motor, calculated using the drive parameters
0 to 10 Hz : Manual control.

(1)
AUtO
bEn [Brake engage freq] [Auto]
(AUtO)
0 to 10 Hz
[Auto]
(AUtO)
* Brake engage frequency threshold.
Note : [Brak e e ngage fre q] (bEn) cannot be higher than [Low s pe e d] (LSP) .
[Auto] (AUtO) : The drive takes a value equal to the rated slip of the motor, calculated using the drive parameters
0 to 10 Hz
: Manual control.

(1)
AUtO
tbE [Brake engage delay] 0 to 5.00 s 0 s
*
Time delay before request to engage brake.

(1)
bEt [Brake engage time] 0 to 5.00 s 0 s
g Brake engage time (brake response time).

(1)
SdC1 [Auto DC inj. level 1] 0 to 1.2 In (2) 0.7 In (2)
*
NOTICE
OVERHEATING AND DAMAGE TO THE MOTOR
Verify that the connected m otor is properly rated for the DC injection current to be applied in term s of amount
and tim e in order to avoid overheating and dam age to the m otor.
Failure to follow these instructions can result in equipment damage.
Level of standstill DC injection current.
Note :
This parameter can be accessed if
[M ove m e nt type ]
(bSt) page 194 is set to
[Trave ling]
(HOr) .

(1)
bEd
*

nO
YES
[Engage at reversal] [No] (
nO
)
Can be used to select w hether or not the brake engages on transition to zero speed w hen the operating direction is reversed.
[No] (nO) : The brake does not engage
[Ye s ]
(YES) : The brake engages
JdC
[Jump at reversal]
[Auto] (AUtO) to 10 Hz [Auto] (AUtO)
*
This parameter can be accessed if
[M ove m e nt type ]
(bSt) page 194 is set to
[Hois ting]
(UEr) .
[Auto] (AUtO) : The drive takes a value equal to the rated slip of the motor, calculated using the drive parameters
0 to 10 Hz
: Manual control
When the reference direction is reversed, this parameter can be used to avoid loss of torque (and consequential release of load)
on transition to zero speed. Parameter is not applicable if
[Engage at re ve rs al] (bEd) = [Ye s ] (YES) .

(1)
AUtO
-
Parameters described in this page can be accessed by:
DRI- > CONF > FULL > FUN- > BLC-