BLEMO ER24 Series, Programming Manual

Page: 266 / 344

Configuration Mode (ConF)
266
Code Nam e / De s cription Adjus tment range Factory s e tting
FLt-
[FAULT MANAGEMENT] (continued)
FqF- [FREQUENCY METER]
FqF
nO
YES
[Frequency meter]
[No] (nO)
Activation of the speed measurement function.
[No] (nO) : Function inactive. In this case, none of the function parameters can be accessed
[Ye s ] (YES) : Function active, assignment only possible if no other functions have been assigned to the "Pulse input" input
FqC

[Pulse scal. divisor]
1.0 to 100.0 1.0
Scaling factor for the "Pulse input" input (divisor). The frequency measured is displayed by means of the
[Puls e in. w ork . fre q.] (FqS) parameter, page
50
.
FqA
nO
-
[Overspd. pulse thd.]
[No] (nO)
Activation and adjustment of overspeed monitoring: [Ove rspeed] (SOF) .
[No] (nO) : No overspeed monitoring
1 Hz to 20.00 k Hz : Adjustment of the frequency tripping threshold on the "Pulse input" input divided by
[Puls e s cal. divis or]
(FqC) .
tdS [Pulse overspd delay] 0.0 s to 10.0 s 0.0 s
Time delay for taking overspeed detected fault into account.
Fdt
nO
-
[Level fr. pulse ctrl]
[No] (nO)
Activation and adjustment of monitoring for the Pulse input (speed feedback):
[Speed fdback loss]
(SPF) .
[No] (nO) : No monitoring of speed feedback
0.1 Hz to 599 Hz
: Adjustment of the motor frequency threshold for tripping a speed feedback detected fault (difference between
the estimated frequency and the measured speed).
Fqt
nO
-
[Pulse thd. wo Run] [No]
(nO)
Activation and adjustment of brake monitoring: [Brak e fe e dback ] (brF) .
If brake logic control [Brak e as s ignm e nt] (bLC) page 194 is not configured, this parameter is forced to [No] (nO) .
[No] (nO) : No brake monitoring
1 Hz to 1,000 Hz : Adjustment of the motor frequency threshold.
tqb [Pulse wo Run delay]
0.0 s to 10.0 s 0.0 s
Time delay for taking brake monitoring into account.
Parameters described in this page can be accessed by:
DRI- > CONF > FULL > FLT- > FQF-