BLEMO ER24 Series, Programming Manual

Page: 53 / 344

Monitoring Mode (MOn)
55
Code Nam e / De s cription Unit
GdLS [GDL status]
Status of the Guard Door Locking safety function.
nO
[Not Se t] (nO) : GDL not set
oFF
[Inact ive ]
(Off) : GDL inactive
Std
[Short De lay] (Std) : Short Delay In Progress
LGD
[Long De lay] (LGd) : Long Delay In Progress
oN
[Active ]
(LGd) : GDL active
LFt
[Inte rnal Err.] (LGd) : GDL internal error
SFFE [Safety fault reg.]
Safety function error register.
Bit0 = 1: Logic inputs debounce time-out (verify value of debounce time LIDT according to the application)
Bit1 Reserved
Bit2 = 1: Motor speed sign has changed during SS1 ramp
Bit3 = 1: Motor speed has reached the frequency limit threshold during SS1 ramp.
Bit4: Reserved
Bit5: Reserved
Bit6 = 1: Motor speed sign has changed during SLS limitation
Bit7 = 1: Motor speed has reached the frequency limit threshold during SS1 ramp.
Bit8: Reserved
Bit9: Reserved
Bit10: Reserved
Bit11: Reserved
Bit12: Reserved
Bit13 = 1: Not possible to measure the motor speed (verify the motor w iring connection)
Bit14 = 1: Motor ground short-circuit detected (verify the motor w iring connection)
Bit15 = 1: Motor phase to phase short-circuit detected (verify the motor w iring connection)
MOn- [1.2 MONITORING]
(continued)
MFb-
[MONIT. FUN. BLOCKS]
For more details on Function Blocks, please refer to dedicated Function Blocks manual.
FbSt [FB status]
Function Block Status.
IdLE
[Idle ] (IdLE) : Idle state
CHEC
[Che ck prog.] (CHEC) : Check program state
StOP
[Stop]
(StOP) : STOP state
InIt
[Init] (InIt) : Initialization state
rUn
[Run] (rUn) : RUN state
Err
[Error]
(Err) : Error state
FbFt [FB fault]
Status of the function blocks execution.
nO
[No] (nO) : No error detected
Int
[Interna l] (Int) : Internal error detected
bIn
[Binary file ] (bIn) : Binary error detected
InP
[Inte rn para.]
(InP) : Internal parameter error detected
PAr
[Para. RW] (PAr) : Parameter access error detected
CAL
[Calculation] (CAL) : Calculation error detected
tOAU
[TO AUX]
(tOAU) : TimeOut AUX task
tOPP
[TO s ynch] (tOPP) : TimeOut in PRE/POST task
AdL
[Bad ADLC] (AdL) : ADLC w ith bad parameter
In
[Input assign.]
(In) : Input not configured
FbI-
[FB IDENTIFICATION]
bUEr
*
[Program version]
Program user version. Can be accessed if [FB s tatus ] (FbSt) is not set to [Idle ] (IdLE) .
bnS
*
[Program size]
Program file size. Can be accessed if
[FB s tatus ]
(FbSt) is not set to
[Idle ]
(IdLE) .
Parameters described in this page can be accessed by:
DRI- > MON- > SAF-