BLEMO ER24 Series, Programming Manual

Page: 212 / 344

Configuration Mode (ConF)
214
PID PRESET REFERENCES
Code Nam e / De s cription Adjus tment range Factory s e tting
FUn-
[APPLICATION FUNCT.] (continued)
PrI-
[PID PRESET REFERENCES]
Function can be accessed if
[PID fe e dback as s .]
(PIF) page 210 is assigned.
Pr2
nO
LI1
...
[2 preset PID ref.] [No] (nO)
If the assigned input or bit is at 0, the function is inactive.
If the assigned input or bit is at 1, the function is active.
[No]
(nO) : Not assigned
[LI1] (LI1) : Logical input LI1
[...] (...) : See the assignment conditions on page 153
Pr4
[4 preset PID ref.]
[No] (nO)
Check that [2 pre s e t PID re f.] (Pr2) has been assigned before assigning this function.
Identical to
[2 pre s e t PID re f.]
(Pr2) page 212 .
If the assigned input or bit is at 0, the function is inactive.
If the assigned input or bit is at 1, the function is active.
rP2
*

(1)
[Preset ref. PID 2]
[M in PID re fe rence] (PIP1) to
[M ax PID re fe re nce ] (PIP2) (2)
300
This parameter can be accessed if [2 pre s e t PID re f.2] (Pr2) is assigned.
rP3
*

(1)
[Preset ref. PID 3] [M in PID re fe rence]
(PIP1) to
[M ax PID re fe re nce ] (PIP2) (2)
600
This parameter can be accessed if
[3 pre s e t PID re f.]
(Pr3) is assigned.
rP4
*

(1)
[Preset ref. PID 4] [M in PID re fe rence] (PIP1) to
[M ax PID re fe re nce ]
(PIP2) (2)
900
This parameter can be accessed if [4 pre s e t PID re f.] (Pr4) is assigned.
(1) The parameter can also be accessed in the [SETTINGS] (SEt-) menu.
(2) If a graphic display terminal is not in use, values greater than 9,999 w ill be displayed on the 4-digit display w ith a period
mark after the thousand digit, for example, 15.65 for 15,650.
These parameters only appear if the corresponding function has been selected in another menu. When the parameters can
also be accessed and adjusted from w ithin the configuration menu for the corresponding function, their description is detailed
in these menus, on the pages indicated, to aid programming.
Parameter that can be modified during operation or w hen stopped.
Parameters described in this page can be accessed by:
DRI- > CONF > FULL > FUN- > PRI-
*
