BLEMO ER24 Series, Programming Manual

Page: 301 / 344

301
Multipoint Screen
Multipoint Screen
Multipoint Screen
Com m unication is possible between a graphic display term inal and a number of drives connected on the same
bus . The addres s es of the drives m us t be configured in advance in the
[COMMUNICATION] (COM-) m enu
us ing the [Modbus Address] (Add) param eter, page 276 .
When a num ber of drives are connected to the s am e graphic dis play term inal, it autom atically dis plays the
following s creens:
Selection of drives for m ultipoint dialog (s elect each addres s and
check the box by pres s ing ENT).
This s creen only appears the firs t tim e the drive is powered up, or if
the "Cfg Add" function key on the MULTIPOINT SCREEN is pres s ed
(s ee below).
ESC
ESC
Selection of a drive for m ultipoint dialog.
ENT
Cfg Add
In m ultipoint m ode, the com m and channel is not dis played. From left to right, the s tate, then the 2 s elected
param eters , and finally the drive addres s appear.
All m enus can be acces s ed in m ultipoint m ode. Only drive control via the graphic dis play term inal is not
authorized, apart from the Stop key, which locks all the drives .
If there is an error on a drive, this drive is dis played.
CONNECTION IN PROGRESS
Vxxxxxx
9
MULTIPOINT ADDRESSES
Address 1
Address 2
Address 3
Address 4
Address 5
Address 6
MULTIPOINT SCREEN
Rdy 0 Rpm 0 A 2
RUN +952 Rpm 101 A 3
NLP +1500 Rpm 1250 A 4
Not connected 5
Rdy + 0 Rpm 0 A 6
Cf g Add
RUN +952 Rpm 101 A 3
Motor speed
+952 rpm
Motor current
101 A
HOME T/K