BLEMO ER24 Series, Programming Manual

Page: 49 / 344

Monitoring Mode (MOn)
51
Code Nam e / De s cription Unit
MOn-
[1.2 MONITORING]
(continued)
MMO-
[MONIT. MOTOR]
I2tM
[I²t overload level]
%
Monitoring of I²t overload level
This paramet er can be accessed if
[I²t mode l activat io n]
(
I2tA
) is set to
[Yes]
(YES) see page 219
IOM-
[I/O MAP]
LIA-
[LOGIC INPUT CONF.]
Logic input functions.
LIA [LI1 assignment]
Read-only parameters, cannot be configured.
It displays all the functions that are assigned to the logic input in order to check for multiple assignments.
If no functions have been assigned,
[No] (nO) is displayed. Use the jog dial to scroll through the functions.
The use of graphic display terminal allow s to see the delay
[LI1 On De lay]
(L1d) . Possible values are the same than in
configuration menu page 127 .
L2A
to
L

A
LA1A
LA2A
[L-- assignment]
All the logic inputs available on the drive are processed as in the example for LI1 above.
LIS1 [State of logic inputs LI1 to LI6]
Can be used to visualize the state of logic inputs LI1 to LI6 (display segment assignment: high = 1, low = 0).
State 1
State 0
LI1 LI2 LI3 LI4 LI5 LI6
Example above: LI1 and LI6 are at 1; LI2 to LI5 are at 0.
LIS2
[State of Safe Torque Off]
Can be used to visualize the state of LA1, LA2 and STO (Safe Torque Off) (display segment assignment: high = 1, low = 0).
State 1
State 0
LA1 LA2 STO
Example above: LA1 and LA2 are at 0; STO (Safe Torque Off) is at 1.
Parameters described in this page can be accessed by:
DRI- > MON- > IOM- > LIA-