BLEMO ER24 Series, Programming Manual

Page: 242 / 344

Configuration Mode (ConF)
242
Code Nam e / De s cription Adjus tment range Factory s e tting
FUn-
[APPLICATION FUNCT.] (continued)
tr0- [TRAVERSE CONTROL]
Note : This function cannot be used w ith certain other functions. Follow the instructions on page 163 .
trC [Yarn control]
[No] (nO)
nO
The Traverse control cycle starts when the assigned input or bit changes to 1 and stops w hen it changes to 0.
[No] (nO) : Function inactive, thereby helping to prevent access to other parameters
[LI1] (LI1) : Logical input LI1
[...]
(...) : See the assignment conditions on page 153
LI1
...
trH
[Traverse freq. high]
0 to 10 Hz 4 Hz
*
Traverse frequency high.

(1)
trL
[Traverse Freq. Low]
0 to 10 Hz 4 Hz
*
Traverse frequency low.

(1)
qSH
[Quick step High]
0 to [Trave rs e fre q. high] (trH) 0 Hz
*
Quick step high.

(1)
qSL
[Quick step Low]
0 to [Trave rs e Freq. Low] (trL) 0 Hz
*
Quick step low .

(1)
tUP
*

[Traverse ctrl. accel.]
0.1 to 999.9 s 4 s
Acceleration traverse control.
tdn
*

[Traverse ctrl. decel]
0.1 to 999.9 s 4 s
Deceleration traverse control.
tbO
*

[Reel time]
0 to 9,999 min 0 min
Reel execution time.
EbO
[End reel]
[No] (nO)
*
The assigned output or relay changes to state 1 w hen the traverse control operating time reaches the
[Re e l tim e ]
(tbO) .
[No] (nO) : Not assigned
[LO1] (LO1) : Logical output LO1
[R2]
(r2) : Relay R2
[dO1] (dO1) : Analog output AO1 functioning as a logic output. Selection can be made if [AO1 as s ignment] (AO1) page 144
is set to [No] (nO) .
nO
LO1
r2
dO1