BLEMO ER24 Series, Programming Manual

Page: 139 / 344

Configuration Mode (ConF)
141
Use of analog output AO1 as a logic output
Analog output AO1 can be us ed as a logic output, by as s igning DO1. In this cas e, when s et to 0, this output
corres ponds to the AO1 m in. value (0 V, or 0 m A for exam ple), and when s et to 1 to the AO1 m ax. value (10
V, or 20 m A for exam ple).
The electrical characteris tics of this analog output rem ain unchanged. As thes e characteris tics are different
from logic output characteris tics , check that it is s till com patible with the intended application.
Code Nam e / De s cription Adjus tment range Factory s e tting
I_O- [INPUTS / OUTPUTS CFG] (continued)
dO1-
[DO1 CONFIGURATION]
dO1
bLC
LLC
OCC
EbO
tSY
dCO
OL01
...
OL10
[DO1 assignment]
[No] (nO)
Identical to [R1 As s ignm e nt] (r1) page 138 w ith the addition of the follow ing parameter values (show n for information only
as these selections can only be configured in the
[APPLICATION FUNCT.]
(FUn-) menu):
[Brk control] (bLC) : Brake contactor control
[Input cont.] (LLC) : Line contactor control
[Output cont]
(OCC) : Output contactor control
[End re e l] (EbO) : End of reel(traverse control function)
[Sync. w obble ] (tSY) : "Counter w obble" synchronization
[DC charging]
(dCO) : DC bus precharging contactor control
[OL01] (OL01) : Function blocks: Logical Output 01
...
[OL10]
(OL10) : Function blocks: Logical Output 10
dO1d [DO1 delay time] 0 to 60,000 ms (1) 0 ms
The delay cannot be set for the
[No drive flt]
(FLt) ,
[Brk control]
(bLC) ,
[Output cont.]
(OCC) and
[Input cont.]
(LLC)
assignments, and remains at 0.
The change in state only takes effect once the configured time has elapsed, w hen the information becomes true.
dO1S
POS
nEG
[DO1 active at]
[1 ] (POS)
Configuration of the operating logic:
[1]
(POS) : State 1 w hen the information is true
[0] (nEG) : State 0 w hen the information is true
The configuration [1 ] (POS) cannot be modified for the [No drive flt] (FLt) , [Brk control] (bLC) and [Input cont.] (LLC)
assignments.
dO1H [DO1 holding time] 0 to 9,999 ms 0 ms
The holding time cannot be set for the
[No drive flt]
(FLt) ,
[Brk control]
(bLC) and
[Input cont]
(LLC) assignments, and
remains at 0.
The change in state only takes effect once the configured time has elapsed, w hen the information becomes false.
(1) 0 to 9,999 ms then 10.00 to 60.00 s on the integrated display terminal.
Parameters described in this page can be accessed by:
DRI- > CONF > FULL > I_O- > DO1-