BLEMO ER24 Series, Programming Manual

Page: 151 / 344

Configuration Mode (ConF)
153
Assignment conditions for logic inputs and control bits
The following elem ents are available for every com m and or function that can be as s igned to a logic input or a
control bit:
[LI1] (LI1) to [LI6] (LI

) Drive w ith or w ithout option
[LAI1 ]
(LAI1) to
[LAI2 ]
(LAI2) Logical inputs
[C101] (C101) to [C110] (C110) With integrated Modbus in [I/O profile ] (IO) configuration
[C111] (C111) to [C115] (C115) With integrated Modbus regardless of configuration
[C201]
(C201) to
[C210]
(C210) With integrated CANopen® in
[I/O profile ]
(IO) configuration
[C211] (C211) to [C215] (C215) With integrated CANopen® regardless of configuration
[C301] (C301) to [C310] (C310) With a communication card in [I/O profile ] (IO) configuration
[C311]
(C311) to
[C315]
(C315) With a communication card regardless of configuration
[CD00] (Cd00) to [CD10] (Cd10) In [I/O profile ] (IO) configuration
[CD11] (Cd11) to [CD15] (Cd15) Regardless of configuration
[OL01]
(OL01) to
[OL10]
(OL10) Regardless of configuration
Note:
In
[I/O profile]
(IO) configuration, LI1 cannot be acces s ed and if
[2/3 wire control]
(tCC) page
85 is s et to [3 wire] (3C) , LI2 , C101 , C201 and C301 cannot be acces s ed either.
Parameters described in this page can be accessed by:
DRI- > CONF > FULL > CTL-
WARNING
LOSS OF CONTROL
Inactive communication channels are not monitored (no error detection in the event of a communication
interruption).
Verify that using the commands and functions assigned to bits C101 to C315 does not result in unsafe
conditions in the event of a communication interruption.
Failure to follow these instructions can result in death, serious injury, or equipment damage.