BENSHAW RediStart EXEXMVRMX3 Series, User Manual

Page: 42 / 222

32
3 - INSTALLATION
3.11.4 Analog Input
The analog input can be configured for voltage or current loop. The input is shipped in the voltage loop configuration unless specified in
a custom configuration. Below TB5 is SW1-1. When the switch is in the on position, the input is current loop. When off, it is a voltage
input. The control is shipped with the switch in the off position.
z
NOTE: The analog input is a low voltage input, maximum of 15VDC. The input will be damaged if control power (115VAC) or line
power is applied to the analog input.
The terminals are as follows:
1) +10VDC Power (for POT)
2) + input
3) - input
4) common
7) shield
See Also Analog Input (I/O 16-20) on page 92.
Starter Type (FUN 07) on page 103.
Theory of Operation section 7.11, Phase Control on page 145.
Theory of Operation section 7.12, Current Follower on page 145.
3.11.5 Analog Output
The analog output can be configured for Voltage or Current loop. The output is shipped in the Voltage loop configuration unless
specified in a custom configuration. Below TB5 is SW1-2. When the switch is in the off position, the output is current. When on, it is a
Voltage loop output. The control is shipped with the Switch on.
z
NOTE:
The analog output is a low voltage output, maximum of 15VDC. The output will be damaged if control power (115VAC)
or line power is applied to the analog output.
The terminals are as follows:
5) analog output
6) common
7) shield
See Also Analog Output (I/O 21-23) on page 94.
3.11.6 SW1 DIP Switch
The SW1 DIP switch on the card changes the analog input and analog output between 0-10V or 0-20mA. The picture below shows how to
adjust the switch to select the desired signal.
(5K-10K ohm)
POTENTIOMETER 4-20mA
4-20mA SOURCE
+
-
TB5 TB5
Figure 16: Analog Input Wiring Examples
V/I
TO METER / ANALOG INPUT CARD
+
-
TB5
Figure 17: Analog Output Wiring Example