BENSHAW RediStart EXEXMVRMX3 Series, User Manual

Page: 107 / 222

If the keypad is selected as local or remote control sources, the [STOP] key cannot be disabled.
If “Enabled”
When this parameter is set to "Enabled", the keypad stop button is enabled and stops the starter regardless of
the selected control source (keypad, terminal or serial).
See Also
Local Source parameter (QST 04) on page 59.
Remote Source parameter (QST 05) on page 60.
Auto Start Selection I/O 27
LCD Display
Range LCD Description
Disabled When Disabled, the Start input must always transition from low to high
for a start to occur.
(Default)
Power When set to Power, a start will occur if the Start input is high while
control power is applied.
Fault When set to Fault, a start will occur if the Start input is high when a
fault is reset.
Power, Fault When set to Power and Fault, a start will occur if the Start input is
high while control power is applied, and a start will occur if the Start
input is high when a fault is reset.
Description
The Auto Start Selection parameter determines whether or not a transition from low to high is required on the
Start input for a start to occur after either a power up or a fault reset. This applies to lockout conditions being
cleared as well. The behavior for a lockout clearing is the same as for a fault being reset.
Jump to Parameter RTD 00
LCD Display
Description
By changing the value of this parameter and pressing [ENTER], you can jump directly to any parameter
within that group.
RTD Module #1 Address RTD 01
LCD Display
Range
Off, 16 to 23
(Default Off)
Description The module #1 address parameter has to be set to the Modbus address of the first RTD module attached to the
soft-starter. The address of the RTD module can be verified by checking the rotary switch on the top of the
RTD module.
97
6 - PARAMETER DESCRIPTION
I/O: Auto Start
27 Disabled
RTD: Jump Code
00
1
RTD: RTDMod1 Addr
01
Off