BENSHAW RediStart EXEXMVRMX3 Series, User Manual

Page: 119 / 222

109
6 - PARAMETER DESCRIPTION
Description
The Miscellaneous Commands parameter is used to issue various commands to the MX
3
starter.
The Reset Run Time command resets the user run time meters back to zero (0).
The Reset kWh command resets the accumulated kilowatt-hour and megawatt-hour meters back to zero (0).
The Reflash Mode command puts the MX
3
into a reflash program memory mode. The reflash mode can only
be entered if the MX
3
starter is idle. When the reflash mode is entered, the MX
3
waits to be programmed.
The onboard LED display shows “FLSH”. The remote display is disabled after entering reflash mode. The
MX
3
does not operate normally until reflash mode is exited. Reflash mode may be exited by cycling control
power.
The Store Parameters command allows the user to copy the parameters into non-volatile memory as a backup.
If changes are being made, store the old set of parameters before any changes are made. If the new settings do
not work, the old parameter values can be loaded back into memory.
The Load Parameters command loads the stored parameters into active memory.
The Factory Reset command restores all parameters to the factory defaults. The default values can be found
in chapter 5.
The standard BIST command will put the starter into the unpowered BIST test. See section 8.9 on page 168.
z
NOTE: The powered BIST test is only offered in the Low Voltage systems.
Time and Date Format FUN 23
LCD Display
Range LCD Description
mm/dd/yy 12h month/day/year 12 hour
mm/dd/yy 24h month/day/year 24 hour
yy/mm/dd 12h year/month/day 12 hour
yy/mm/dd 24h year/month/day 24 hour
dd/mm/yy 12h day/month/year 12 hour
dd/mm/yy 24h day/month/year 24 hour
Description Sets the date display format and 12 hour or 24 hour time display.
z
NOTE: The system clock does not recognize daylight savings time.
Time FUN 24
LCD Display
Description
Sets the present time.
See Also Time and Date parameter (FUN 23) on page 109.
Date FUN 25
LCD Display
Description
Sets the present date.
See Also Time and Date parameter (FUN 23) on page 109.
FUN: T/D Format
23
mm/dd/yy 12h
FUN: Time
24 present time
FUN: Date
25 present date