BENSHAW RediStart EXEXMVRMX3 Series, User Manual

Page: 117 / 222

107
6 - PARAMETER DESCRIPTION
TruTorque Accel If the tachometer signal is lost the starter will fault. However the start mode
parameter will be set to TruTorque control acceleration so that when the fault is
reset the starter will start in Current control mode.
KW (Power) If the tachometer signal is lost the starter will fault. However the start mode
parameter will be set to KW (Power) so that when the fault is reset the starter
will start in Current control mode.
Description If the tachometer detects the feedback signal is not valid one of the above actions will be taken depending on
the value of the Tach Loss Action user parameter.
Communication Address FUN 16
LCD Display
Range 1 – 247 (Default: 1)
Description
The Communication Address parameter sets the starter’s address for Modbus communications.
See Also Local Source parameter (QST 04) on page 59.
Remote Source parameter (QST 05) on page 60.
Communication Baud Rate parameter (FUN 17) on page 107.
Communication Timeout parameter (FUN 18) on page 107.
Communication Byte Framing parameter (FUN 19) on page 108.
Communication Baud Rate FUN 17
LCD Display
Range 1200, 2400, 4800, 9600, 19200 bps (Default: 19200)
Description
The Communication Baud Rate parameter sets the baud rate for Modbus communications.
See Also
Local Source parameter (QST 04) on page 59.
Remote Source parameter (QST 05) on page 60.
Communication Address parameter (FUN 16) on page 107.
Communication Timeout parameter (FUN 18) on page 107.
Communication Byte Framing parameter (FUN 19) on page 108.
Communication Timeout FUN 18
LCD Display
Range
Off, 1 – 120 seconds
(Default: Off)
Description The Communication Timeout parameter sets the time that the starter continues to run without receiving a valid
Modbus request. If a valid Modbus request is not received for the time that is set, the starter declares an F82
(Modbus Time Out). The starter performs a controlled stop.
See Also
Local Source parameter (QST 04) on page 59.
Remote Source parameter (QST 05) on page 60.
Stop Mode parameter (CFN 15) on page 70.
Controlled Fault Stop Enable parameter (PFN 25) on page 85.
Communication Address parameter (FUN 16) on page 107.
Communication Baud Rate parameter (FUN 17) on page 107.
FUN: Com Drop #
16
1
FUN: Com Baudrate
17
19200
FUN: Com Timeout
18
Off