BENSHAW RediStart EXEXMVRMX3 Series, User Manual

Page: 12 / 222

Using This Manual
Layout
This manual is divided into 9 sections. Each section contains topics related to the section. The sections are as
follows:
•
Introduction
•
Technical Information
•
Installation
•
Keypad Operation
•
Parameters
•
Parameter Descriptions
•
Theory of Operation
•
Troubleshooting & Maintenance
•
Appendices
Symbols There are 2 symbols used in this manual to highlight important information. The symbols appear as the
following:
Electrical Hazard
warns of situations in which a high voltage can cause physical injury, death and/or
damage equipment.
Caution
warns of situations in which physical injury and/damage to equipment may occur by means other
than electrical.
Highlight
mark an important point in the documentation.
2
1 - INTRODUCTION
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
Only qualified personnel familiar with medium voltage equipment are to perform work described in this set of instructions.
Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices. See NFPA 70E.
Turn off all power before working on or inside equipment.
Use a properly rated voltage sensing device to confirm that the power is off.
Before performing visual inspections, tests, or maintenance on the equipment, disconnect all sources of electric power.
Assume that circuits are live until they have been completely de-energized, tested, and tagged. Pay particular attention to
the design of the power system. Consider all sources of power, including the possibility of backfeeding.
Replace all devices, doors, and covers before turning on power to this equipment.
Failure to follow these instructions will result in death or serious injury.
DANGER