Agilent Technologies 4284A, Operation Manual

Page: 148 / 460

NNNNNNNNNNNNNNNNNNNNNNNNNN
BIAS [A]
2. Select and press a softkey to set the list sw eep measuremen t sw eep
parameter.
Sw eep P oints and Limit
Mode
Description
The list sw eep function p ermits en try of up to 10 p oints and
measuremen t limits. Figure 4-24 sho ws the a v ailable elds for setting
the sw eep p oints, the limit parameter, and the high/lo w limit v alues.
Figure 4-24. List Sw eep Settings
Note
When only the low limits of the sw eep p oints are set, the devices
whose selected parameter's data are equal, or are ab o v e the low
limits are sorted as IN. When only the high limits of the sw eep p oints
are set, the devices whose selected parameter's data are equal, or are
b elow the high limits are sorted as IN.
Note
The comparison results are alw a ys IN when the paramter selection
for the limit function is p erformed, but the low/high limit v alues
aren't en tered.
Note
The comparison results is alwa ys LO W under the follo wing
conditions (which are equal to the condition at <ST A TUS> 6= 0 in
the data format.)
Analog Bridge is un balanced.
A/D con v erter isn't w orking.
Signal source is o v erloaded.
ALC is unable to regulate.
4-52 MEAS SETUP Menu