ABB ACQ810, Firmware Manual

Page: 135 / 376

Parameters 135
09.10 Int logic ver Displays the version of the logic on the main circuit board of
the drive. -
09.20 Option slot1 Displays the type of the optional module in option slot 1.
0 = No option, 1 = No comm, 2 = Unknown, 6 = FIO-01,
7 = FIO-11, 8 = FPBA-01, 9 = FPBA-02, 10 = FCAN-01,
11 = FDNA-01, 12 = FENA-01, 13 = FENA-02,
14 = FLON-01, 15 = FRSA-00, 16 = FMBA-01,
17 = FFOA-01, 18 = FFOA-02, 19 = FSEN-01, 21 = FIO-21,
22 = FSCA-01, 23 = FSEA-21, 24 = FIO-31, 25 = FECA-01 1 = 1
09.21 Option slot2 Displays the type of the optional module in option slot 2. See
09.20 Option slot1 .
1 = 1
10
10 Start/stop/dir
Start/stop/direction, run enable and emergency stop source
selections; start inhibit and start interlock configuration.
10.01 Ext1 start func Selects the source of start and stop commands for external
control location 1 (EXT1).
Note: This parameter cannot be changed while the drive is
running.
Not sel No start or stop command sources selected. 0
In1 The source of the start and stop commands is selected by
parameter
10.02 Ext1 start in1 . The state transitions of the
source bit are interpreted as follows:
1
3-wire The sources of the start and stop commands is selected by
parameters
10.02 Ext1 start in1 and 10.03 Ext1 start in2 .
The state transitions of the source bits are interpreted as
follows:
2
FBA The start and stop commands are taken from the fieldbus
Control Word selected by parameter
50.15 Fb cw used .
3
D2D Reserved. 4
In1F In2R The source selected by 10.02 Ext1 start in1 is the forward
start signal, the source selected by 10.03 Ext1 start in2 is the
reverse start signal.
5
No. Name/Value Description FbEq
State of source
(via par 10.02 )
Command
0 -> 1 Start
1 -> 0 Stop
State of source 1
(via par. 10.02 )
State of source 2
(via par. 10.03 )
Command
0 -> 1 1 Start
Any 1 -> 0 Stop
Any 0 Stop
State of source 1
(via par. 10.02 )
State of source 2
(via par. 10.03 )
Command
0 0 Stop
1 0 Start forward
0 1 Start reverse
1 1 Stop