ABB ACH580 Series, User Manual

Page: 24 / 257

ACH580 E-Clipse bypass and packaged drive user manual 15
Installation
Install the line input wiring
Line input connections – Vertical E-Clipse Bypass
configurations
Connect the input power to the terminals at
the bottom of the disconnect switch or circuit
breaker as shown below. Also see
Connection and wiring diagrams – Vertical
E-Clipse Bypass
on page 8 . Connect the
equipment grounding conductor to the
ground lug near the input power connection
point.
Line input connections – Standard E-Clipse
Bypass configurations (wall mounted)
Connect input power to the terminals of the disconnect switch or circuit breaker.
Connect the equipment grounding conductor to the ground lug at the top of the
enclosure. For connection points for Standard E-Clipse Bypass configurations, refer
to
Connection and wiring diagrams – Vertical E-Clipse Bypass on page 8 and
Connection and wiring diagrams – Box E-Clipse Bypass on page 10 .
Note: Route cables through the cable guides on the left side of the enclosure. Use
separate conduits for input power and motor cables. Follow the guides to separate
the cables from each other.
Power connections – Vertical E-Clipse Bypass configurations
Line input connections
Connect the input power to the terminals at the bottom of the disconnect switch or
circuit breaker. Also see
Connection and wiring diagrams – Vertical E-Clipse Bypass
on page 8 . Connect the equipment grounding conductor to the ground lug near the
input power connection point.
Motor connections
Connect the motor cables to the terminals at the bottom of the bypass section. Also
see
Connection and wiring diagrams – Vertical E-Clipse Bypass on page 8 . Connect
the motor grounding conductor to the ground lug near the motor cable terminal block
connection point.
Power connections – Standard E-Clipse Bypass configurations (wall mounted)
Line input connections
Connect input power to the terminals of the disconnect switch or circuit breaker.
Connect the equipment grounding conductor to the ground lug at the top of the
enclosure. The figure below shows the connection points for Standard E-Clipse
Bypass configurations. Also see
Connection and wiring diagrams – Box E-Clipse
Bypass on page 10 .
Input Power Cables
Ground