172
ACH580 E-Clipse bypass and packaged drive user manual
Fieldbus adapter
Bypass relay output control
Using the fieldbus for relay output control requires:
• Bypass parameter values set as defined below.
• Fieldbus controller supplied, binary coded, relay command(s) in the appropriate
location. (The location is defined by the Protocol Reference, which is protocol
dependent.)
Note:
Relay status feedback occurs without configuration as defined below.
Communication fault
When using fieldbus control, specify the bypass action if communication is lost.
Diagnostics – FBA
Fault Handling
The ACH580 or E-Clipse provides fault information as follows:
• The control panel display shows a fault code and text. See
starting on
page
for a complete description.
• Parameters 0401 LAST FAULT, 0402 PREVIOUS FAULT1 and 0403 PREVIOUS
FAULT2 store the most recent faults.
Bypass Parameter
Value
Description
Protocol
Reference
Modbus TCP
1401
RELAY OUTPUT 1
16
(COMM
CTRL)
Relay Output 1 controlled by fieldbus.
433031 bit 0
1402
RELAY OUTPUT 2
Relay Output 2 controlled by fieldbus.
1403
RELAY OUTPUT 3
Relay Output 3 controlled by fieldbus.
1410
RELAY OUTPUT 4
Relay Output 4 controlled by fieldbus.
433031 bit 3
1411
RELAY OUTPUT 5
Relay Output 5 controlled by fieldbus.
Bypass Parameter
Value
Protocol Reference
0122
RO 1-3 STATUS
Relay 1…3 status.
400278
0123
RO 4-5 STATUS
Relay 4…5 status.
400279
Drive Parameter
Value
Description
Protocol
Reference
50.02
FBA A COMM
LOSS FUNC
0 = No action
1 = Fault
2 = Last speed
3 = Speed ref safe
4 = Fault always
5 = Warning
Set for appropriate drive/
bypass response. NOTE: If the
system is in bypass mode
when communication is lost,
choices 2 and 3 will cause the
bypass contactor to remain in
its present state.
–
50.03
FBA A COMM
LOSS T OUT
Set time delay before acting on a communication
loss.
–
Summary of Contents for ACH580 Series
