78
multi
MAUS
4 – Brake time
5 – Maximum speed
29 – Decoder settings
Only programmable in menu mode (see
3.1.7.
on page
64
).
Changing the speed steps
You will fi nd many tips and information about model railway electrical and digital systems in
the large ROCO electrics manual, item number 82071, which you can obtain as a CD-ROM
from specialist dealers.
The ROCO ROCOMOTION system control also offers a variety of options, including ones that
work together with the
multi
MAUS
. Information about ROCOMOTION is available from specialist
dealers or at
www.roco.cc
.
4.8. Error messages
ERR 1
: Programming is not supported.
ERR 2
: No confi rmation was received from the decoder during programming / readout.
Check whether connection to the decoder is disturbed by contaminated tracks or wheel
contacts. If necessary, re-rail the locomotive.
Check whether a capacitor is installed somewhere in the track system.
ERR 3
: A short circuit has occurred during programming / reading.
Check whether the locomotive has been correctly re-railed and that the wiring does not
have any faults.
It is possible that the locomotive is standing on a polarised frog (the turnout position, how-
ever, does not correspond to the route of the locomotive).
It is possible that the decoder is not correctly connected with a newly converted
locomotive.
ERR 4
: Not possible in “POM” mode.
This error occurs when the
multi
MAUS
has been changed to “POM” mode (see
3.2.3.
on
page
66
) and CV1 (locomotive address) has to be programmed. Program the CV1 on a
separate programming track in “CV mode” (see chapter
3.2.3.
on page
66
).
ERR 5
: Programming mode is active.
ERR 6
: Not possible because the track voltage is off (occurs in “POM” mode).
ERR 7
: The library is empty (“LOC” – “DELETE” menu).
ERR 8
: The library is full (e.g. when entering a new locomotive).
You can save a maximum of 64 locomotives in the library. Control the locomotive using loco-
motive address mode or use another
multi
MAUS
.
ERR 9
: The locomotive was not found (“LOC” – “SEARCH” menu).
The locomotive address is not yet assigned in the library.
ERR 10
: A locomotive with the same address already exists (when entering a new
locomotive into the locomotive library).
ERR 11
: The address of the locomotive is outside the valid value range.
For example, you are using a Lokmaus 2 as a master which only supports 99 locomotive
addresses.
MENU
4
ghi
+
MENU
5
jkl
+
MENU
+
/
Part 4 - Appendix
