59
ENGLISH
Confi rm with OK. After the last
“PROG” display, the
multi
MAUS
returns to driving mode.
Note
:
If you have changed CV1
of a locomotive, check whether
the address specifi cation of the
locomotive in the locomotive
library still matches.
As shown in this example, you can also program new values for CVs 2, 3, 4 and 5. All you have to do
is press the MENU button at the same time as the digit of the function buttons corresponding to the
CV and then proceed as in the example above.
If you set value “8” in CV8 (another value cannot be entered), all CVs of the decoder are reset to the
factory values.
2.7. Short circuit and overload
If a short circuit or an overload occurs in the system, the
multi
MAUS
indi-
cates this in the display with two fl ashing symbols: A fl ash and the STOP
symbol. The power supply to the system is switched off at the same time.
If it is a short circuit, e.g. caused by a derailed wagon or train, eliminate the
fault. When the STOP button is pressed, the system is switched on again
with a delay of about one second.
If the fault is not a short circuit, the cause may be system overload, for
instance simultaneous operation of several locomotives. If this occurs frequently, the power supply of
your system is not suffi cient. Connect (another)
BOOSTER for this purpose (see „Appendix“ on page
70
). Under no circumstances should you use a normal transformer to directly feed in power; the
multi
MAUS
and Z21 will be destroyed.
Part 2 - Operation of the
multi
MAUS
