77
ENGLISH
4.5.6. X-BUS
The X-BUS is the connection between the digital components (
multi
MAUS
, Z21, BOOSTER, in-
terface, etc.) that not only ensures the power supply, but is also responsible for data exchange.
The master mouse always has a fi xed address, other devices automatically search for free
addresses so that you normally do not have to set anything.
4.6. Tips, notes and quick help
Library or locomotive address mode:
Selected locomotive does not react.
• Does the locomotive address in the library match the
address stored in the locomotive decoder?
• Emergency stop or selective emergency stop initiated?
• Select another address in locomotive address mode.
Turnouts react incorrectly or turnout set-
ting does not match in the display.
• Turn plug on turnout drive.
POM mode: Programming is confi rmed,
but the decoder does not react to a
changed value.
• Decoder requires a reset: Switch the track voltage
off and on again with the “STOP” (emergency stop)
button. Also observe the decoder instructions here.
It is not possible to reset (
3.3.5.
on page
68
) the
multi
MAUS
.
• In this case, it helps to unplug the cable and press
the Shift and MENU buttons at the same time when
plugging it in again.
• This completely resets the
multi
MAUS
to the factory
settings. Since this also deletes the locomotive library,
this step should be considered carefully.
Scrolling in locomotive address mode is
sluggish or does not work at all.
There is a problem with the X-BUS. Switch the system off,
then back on again. If necessary, check whether the set-
ting is “Automatic” in the
3.3.2.
menu item. Two devices
may have the same X-BUS address.
4.7. Lokmaus 2 / R3 – multiMAUS PROGRAMMING HELP
In the manuals delivered so far for ROCO digital items (such as the 42624 turnout drive), only the
standard programming mode with locomotive mouse 2 / R3 was described. In the following you will
fi nd a table that compares the programming process of the Lokmaus
2 / R3 with the quick program-
ming function (see
2.6.
on page
57
) of the
multi
MAUS
.
For more information, see the locomotive mouse 2 / R3 manual. Observe the instructions supplied with
the decoder to program the CV29.
CV
multi
MAUS
1 – Address
2 – Minimal speed
3 – Start-up delay
MENU
1
+
MENU
2
abc
+
MENU
def
3
+
Part 4 - Appendix
