47
ENGLISH
1. BASICS
1.1. Connecting the
multi
MAUS
For a functional ROCO digital system with the
multi
MAUS
, you need the following items:
•
An amplifi er
10764,
• A switched power supply 10851,
• And a feed element 61190 for the GEOLINE track system. If you use a different track system,
make sure that there is no capacitor in the connection track.
Which devices you can use with the
multi
MAUS
can be found in the chapter “Compatibility of the
multi
MAUS
” in part
4
of this manual.
Please make sure to observe the following instructions before starting connection work:
If you use third-party components together with ROCO components, there is no warranty in
the event of damage or malfunction. The warranty claim also expires when the housing of the
multi
MAUS
is opened.
Please carry out all connection work only with the operating voltage switched off (exception:
Connection of additional X-BUS devices, see below). Work carefully and make sure that no
short circuits occur when connecting to the track system! An incorrect connection can destroy
the digital components. Please contact your specialist dealer for advice if necessary.
To operate the digital system without malfunctions, you should not extend the connection cable
to the master mouse.
Under no circumstances should you connect a normal transformer to the same circuit in parallel
to the digital control. This will destroy the digital amplifi er!
1.
Plug the cable of the connecting track into the “Track Out” socket of the amplifi er.
2. Plug the hollow plug that is connected to the transformer via the two-pole cable into the “Power
In” socket.
3. Connect the
multi
MAUS
and the amplifi er with the supplied cable. Plug the cable into the connec-
tion socket of the amplifi er marked “Master”.
4. Only now should you connect the transformer to the mains socket. This will prevent damage to
the digital system.
The socket labelled “Slave” is used to connect another
multi
MAUS
, a Lokmaus 2 /R3, the RouteControl
10772 or a PC to the ROCOMOTION software. In this case, you should have switched on the system
to enable smooth automatic assignment of the X-BUS addresses in the system. If several of these
devices are to be connected, you will need data bus distributor 10758.
If you use a Lokmaus 2 as master, some functions of a
multi
MAUS
connected as a slave cannot be
used. We therefore recommend that you always use a
multi
MAUS
as a master. Please also refer to
the chapter “Master and slave principle” in section
3
of the manual.
Note on the manual
A “
” before a word refers to an explanation in the “Glossary” in section
4
of the manual.
“+” in the sketches means to press the two above-mentioned buttons simultaneously.
“/” in the sketches means to select one of the two buttons to press.
Unless otherwise mentioned, the term "Z21" refers to all different Z21 variants (Z21, z21,
z21start).
Part 1 - Basics
